INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
EO15-33002
2. Strip Module: B-SX908-H-QM-R
2- 3
7. Install the strip unit into the printer with the four FL-4x6 screws which were removed in step 4.
8. Connect the strip harness to the connector on the printer through the opening of the main frame.
9. Attach the operation panel and the left side cover on the printer.
10. Close the top cover and right side cover. After that, perform an operation check for a proper strip issue.
•
Media loading procedure------------- Owner’s Manual, Section 2.4
•
Operation check------------------------ Owner’s Manual, Section 2.10
•
System mode setting------------------ System Mode Manual
•
Cleaning --------------------------------- Owner’s Manual, Section 4.1.6
FL-4x6 Screw
FL-4x6 Screw
FL-4x6 Screw
Strip Unit
Connector
Opening
Main Frame
Strip Harness
