Toshiba 51HX93, Руководство по обслуживанию

Страница: 21 / 65

– 21 –
GENERAL ADJUSTMENTS
SPECIFIC INFORMATIONS
PROGRAMMING CHANNELS INTO THE TV'S CHANNEL MEMORY
When you press CHANNEL 8 or 9 on the remote control or TV front panel, your TV will stop only on the channels stored in the
TV’s channel memory.
Follow the steps below to program channels into the TV’s channel memory.
Programming channels automatically
Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are pro-
grammed automatically, you can manually add or erase indi-
vidual channels.
Note:
• If you already programmed channels automatically
during the Quick Connect Guide assisted setup, you
can skip to “Manually adding and deleting channels
in the channel memory” on the next page.
• You must configure the antenna input sources before
programming channels.
• The automatic channel programming process does
NOT erase channels that were previously pro-
grammed into the TV's memory, but adds newly found
channels to the existing set of programmed channels.
To remove a channel from the memory, you must
manually delete it.
• To tune the TV to a channel not programmed in the
channel memory, you must use the Channel Number
buttons on the remote control.
• Programming channels for an antenna input
configured for CABLE will take substantially longer
than for an antenna input configured for ANTENNA.
This is normal; however, once channel programming
is completed, you should not have to repeat the pro-
gramming process again unless your Cable TV serv-
ice lineup changes significantly.
To program channels automatically:
1
Make sure you have configured the antenna input sources.
2
Press MENU and open the SETUP menu.
3
Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 4.)
4
Open the TERRESTRIAL menu, highlight CHANNEL
PROGRAM, and press ENTER.
5
Highlight ANT 1 or ANT 2, depending on which antenna
input you want to program channels for, and then press
ENTER to start automatic channel programming.
The TV will automatically cycle through all the channels
for the antenna input you selected, and store all active
channels in the channel memory. While the TV is cycling
through the channels, the message “Scanning channels,
please wait” appears.
To cancel channel programming, highlight ABORT and
press ENTER.
6
When channel programming is done, press CHANNEL 8
or 9 to view the programmed channels.