13
Introduction / Getting started
6
Press
OK
to display the
Intelligent AutoView
menu (
-
page 21).
Press
or
to select
Yes
or
No
.
7
Press
OK
to display the
Auto Tuning
setup
menu.
Auto Tuning
Tuning Mode
Start Scan
DTV and ATV
Scan Type
Auto Signal Booster
Quick Scan
On
8
Select
Start Scan
and press
OK
to start the
automatic search.
The television will start to search for available
DTV
and/or
ATV
channels. The progress bar will
indicate the scan status.
You must allow the television to complete
the search.
Frequency : 218.000 MHz
Auto Tuning
1%
0
Progress
DTV
ATV
Waiting...
Found
When the search is complete, the search result
is displayed.
•
If multiple areas are detected, the
Region
Selection
screen appears. Press
or
to
select a region, select
Next
and press
OK
.
The
Auto Tuning
screen will display the total
number of services found.
9
Press
or
to view the
DTV
(digital channel)
or
ATV
(analogue channel) lists.
10
Press
or
to move through the list to select
a channel and press
OK
to view.
In
ATV
mode, some areas may receive duplicate
stations. There may not be a clear picture or the
signal may be weak, so the station order can be
changed using
ATV Manual Tuning
.
Remember:
Press
TV
at any time to select between
ATV
and
DTV
modes.
11
Press
or
to select
Enable DTV Clock
and
use
or
to select
On
.
This changes the time displayed when watching
the TV to the time received via the digital
broadcasting signal. The time received by the
DTV Clock is displayed.
If the time needs to be adjusted according
to the area in which you live, perform the
following procedure.
12
Press
or
to select
Off set
and use
or
to adjust the time.
The time can be adjusted in 30 minute
increments. The adjusted time is displayed in
Display Clock.
13
Press
or
to select
Done
and press
OK
.
If time information is not being received
correctly via digital broadcasting, or digital
broadcasting is not available in your area,
follow the steps described in "Setting the clock
manually" (
-
page 19) to set the clock
manually.
NOTE:
•
If the time is not set, some features such as recording
and the programme guide cannot be used.
•
When you set the clock manually, it may not be
perfectly accurate. It is recommended that you
adjust the clock regularly.
•
If you unplug the power supply, the time information
will be deleted. A message will be displayed the next
time the TV is turned on. Set the correct time again.
•
If the time information is incorrect, programmed
recording may not be performed properly.
Furthermore, if the time information diff ers
according to the currently viewed channel,
programmed recording may not be performed
properly depending on tuning operations.
NOTE:
The
Quick Setup
menu can also be displayed from
the
SETUP
menu at any time while watching TV
broadcasts.
32405055L2550̲EN.indd 13
32405055L2550̲EN.indd 13
27/02/02 15:40:08
27/02/02 15:40:08
