Toshiba 23WL46B, Руководство пользователя

Страница: 20 / 31

- 19 -
Personal Preferences (PP)
All the preset values will be restored, when
pressing " PP ".
33
Sound Indicator
The alternatives of the indicator are Mono,
Stereo, Dual I and Dual II. This indicator is
displayed under the programme number in-
dicator on the screen. " I-II " button is used to
select Mono or Stereo, or Dual I or Dual II.
0212
In Mono broadcast or in forced-mono (for
stereo broadcast).
67(5(2
In Stereo broadcast.
'8$/,
If dual broadcast detected. Dual I is selected
in default and also can be selected after
Dual II by Remote Control.
'8$/,,
If Dual II selected by Remote Control.
,, ,
Picture Mode
Picture mode OSD is displayed when “ ”
button is pressed. Picture mode can be
changed to Auto, 4:3, 16:9, Cinema, Sub-
title, Zoom or Panorama by pressing “ ”
button.
Sleep Timer Indicator
It is displayed on the upper right of the
screen when a new programme is entered
by digit button or by pressing “ P<P ”, “-P/CH”,
“P/CH+” , “ ”, “
(;7
” or “ ” button. If sleep
timer is activated it is displayed with the TV
status and erased with it after 3 seconds.
In last minute, sleep timer indicator is dis-
played on the upper right of screen and
stays there until the TV goes automatically
to stand-by.
Mute Indicator
It is placed in the upper middle of the screen
when enabled, and it stays there until it is
disabled.
To cancel mute, there is two alternative; the
first one is pressing to " " button, this vol-
ume is set to the preceding value, and the
second one is increasing the volume level,
thus it starts at the minimum level to in-
crease. By decreasing the volume level in
mute state, mute will not be ignored, only the
volume level will decrease. If mute canceled
after decreasing the volume level, the vol-
ume will valid with the decreased level.
No-Signal Detection (TV)
If no valid signal detected, it takes 5 minutes
for the switching to the Stand-By mode un-
less any signal detected or no any Remote
Control command is accessed.
After a Remote Control command (if No-Sig-
nal Timer is active) the timer stops and if no
signal detected again the timer is initialized
to 5 minutes and starts 3 seconds later
again to count down.
It is not valid in AV mode.
No-Signal Detection (PC)
If no valid signal detected for 5 minutes sys-
tem goes to Stand-By mode. To switch on
the system press “ ” button.
As the last status feature, system starts from
TV or PC, whichever was the status before
stand-by or switch-off. Note that SCART in-
puts have the precedence on both TV and
PC.
2309W-ENG-1550UK (TOSHIBA UK)-17 INCH TFT.p65 13.05.2004, 18:55 19