Toshiba 1600XPi SERIES, Инструкция по установке и эксплуатации, Страница: 48 / 140

38 1600XPi Series UPS Installation and Operation Manual – 60616-014
16 Screen Tab: Settings
The Parameter Table in Appendix B lists the 1600XPi Settings parameters that can be viewed in the MONITOR tab.
Example: The Settings parameter
Batt Test Freq (Battery Test Frequency) can be viewed by USR (User) level and
above. However, only ADM (Administrators) and above can edit )change) the parameter value.
Each key displays a block of relevant command parameters:
Key: Cmd ID - (Range) Parameter type
•
ID –
(000-099) UPS specific information such as serial number, software versions, installation date.
•
Input – (100-199) Input measured/calculated data such as input voltage, frequency, current, power, over-/under- voltage
settings.
•
Output – (200-299) Output measured/calculated data such as output voltage, frequency, current, power, over-/under-
voltage settings.
•
Bypass – (300-399) Bypass data such as configuration, voltage, current, power, OV detection level.
•
DC Bus –
(400-499) Data such as Total voltage, rated voltage, Positive and Negative bus voltages.
•
Batt – (500-599) Battery voltage, charger status, total discharges, shutdown voltage.
•
Ctrl/Cfg – (600-699) Control and configuration list system and battery temperatures, system status, startup delay, auto-
transfer window, restart mode.
•
History – (700-799) History lists metrics like system operation time, total over loads, hi system temp.
•
Disp/Reye –
(800-849) Display specific parameters like Disp. Firmware version, sleep timer, buzzer status, display
calibration points, and RemotEye 4 settings.
(850-859) lists the RemotEye 4 IP address, IP Mask, Status, Baud Rate, datalink status.
On-Line
Main Monitor Settings Records
12:35 PM
INV
HOME
USR
Ctrl/Cfg History
ID Input
Output Bypass
DC Bus Batt
Disp/Reye
Debug
SETTINGS OPENING SCREEN
96% 100%