Toro Z355 Z-Master, Руководство оператора

Страница: 27 / 60

27
4.
Flip seat up and unlatch plenum from both sides of
blower inlet (Fig. 41).
5. Pull plenum out from blower housing and place it on
the ground (Fig. 41).
6. Pull or slide plenum out from between deck and
traction tire (Fig. 41).
3 1
4
m–4851
5 7 2
2 6
8
Figure 41
1. Bracket
2. Plenum cable
3. Washer
4. Nut 5. Plenum
6. Plenum cable guide
7. Plenum latches
8. Blower housing
Installing the Plenum
1. Tilt deck to upright position. Refer to Tilting the
Mower on page 19.
2. Slide plenum, with blower end in first, between deck
and traction tire.
3.
Flip seat up, reach down and direct plenum into
blower housing. Ensure the plenum latches lock into
both sides of blower housing (Fig. 41).
4. Reach through from lefthand side in front of traction
tire, lift plenum and wind cable counter clockwise
around plenum cable guide (Fig. 41).
Using a Rollover Protection
System (ROPS)
A ROPS is available and its use is recommended for areas
where there are slopes, drop–offs or water. Contact an
Authorized Service Dealer for information on obtaining
ROPS for your machine.
Important When operating a machine with ROPS
always use the seat belt and secure the seat base.
Transporting the Machine
Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary lighting
and marking as required by law. Please carefully read all
of the safety instructions. Knowing this information could
help you, your family, pets, or bystanders avoid injury.
To transport the machine:
• Lock the brake and block the wheels.
•
Securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes.
• Secure a trailer to the towing vehicle with safety
chains.
Driving on street or roadway without turn signals,
lights, reflective markings, or a slow moving
vehicle emblem is dangerous and can lead to
accidents causing personal injury.
Do not drive machine on a public street or
roadway.
Warning
Loading Machines
Use extreme caution when loading units on trailers or
trucks. One full width ramp that is wide enough to extend
beyond the rear tires is recommended instead of individual
ramps for each side of the unit (Fig. 42). If it is not
possible to use one full width ramp, use enough individual
ramps to simulate a full width continuous ramp.
The ramp should be long enough so that the angles do not
exceed 15 degrees (Fig. 42). A steeper angle may cause
mower deck components to get caught as the unit moves
from ramp to trailer or truck. Steeper angles may also
cause the unit to tip backward. If loading on or near a
slope, position the trailer or truck so it is on the down side
of the slope and the ramp extends up the slope. This will
minimize the ramp angle. The trailer or truck should be as
level as possible.
Important Do Not attempt to turn the unit while on
the ramp; you may lose control and drive off the side.