Toro Z-Stand 105-1621, Руководство по установке

Страница: 4 / 8

Installation Instructions
4
m–5357
3
1
6
2
5
4
7
8
Figure 5
1. Left front caster housing
2. Z–Stand bracket
3. Bolt, 5/16 x 3–1/4 in.
4. Lock Nut, 5/16 in.
5. Lock Nut, 1/4 in.
6. Bolt, 1/4 x 3/4 in.
7. Lanyard
8. Bracket Pin
Using the Z–Stand
The Z–Stand is used for raising the front end of the
machine. This allows for cleaning of the deck and
removal of the blades.
Unit could fall onto someone and cause serious
injury or death.
•
Use extreme caution when operating unit
on Z–Stand.
•
Use only for cleaning deck and removing
blades.
•
Do not keep unit on Z–Stand for extended
periods of time.
•
Always shut engine off and set parking
brake before performing any maintenance
to deck.
Warning
Driving up onto the Z–Stand
1. Raise deck to transport position.
2. Remove bracket pin (Fig. 6).
5
1
3
m–5375
4
2
Figure 6
1. Z–Stand
2. Latch
3. Bracket
4. Bracket Pin
5. Bottom of slot
3. Raise latch. Swing stand foot out front and slide stand
toward machine, into the bottom of slot (Fig. 6 and 8).
4. Remove the cotter hair pin and clevis pin (Fig. 7).
5. Pull out the foot part of stand and insert clevis pins and
cotter hair pins (Fig. 7).
3
1
2
m–5380
Figure 7
1. Clevis Pin
2. Hair pin cotter
3. Z–Stand foot
6. Set foot of stand on the ground and rest latch on pivot
tab (Fig. 8).
7. Start engine and put at half throttle.
Note: For best results, place foot of stand
into seams in sidewalks or into turf
(Fig. 8).