Toro Z-Stand 105-1621, Руководство по установке

Страница: 2 / 8

Installation Instructions
2
DESCRIPTION USE QTY.
Z–Stand foot
Z–Stand tube
Thrust washers
Lynch pin
Hair pin cotter
Clevis pin
1
1
2
1
2
2
Install 100 Series Z–Stand
Z–Stand bracket
Bolt, 5/16 x 2–3/4 in.
Lock Nut, 5/16 in.
Bolt, 1/4 x 3/4 in.
Lock Nut, 1/4 in.
Lanyard
1
1
1
1
1
1
Install 100 Z–Stand bracket
The following instructions are for installing the
Z–Stand on a 100 Series Z–Master.
Assemble 100 Series Z–Stand
Hub
1. Install the bracket latch to the Z–Stand hub with
a bolt (3/8 x 1–1/2 in.) and lock nut (3/8 in.)
(Fig. 1).
Note: Tighten the nut and bolt. Then,
unscrew it one full turn or until the
latch will freely rotate (Fig. 1).
m–5357
2
1
3
4
Figure 1
1. Bracket latch
2. Z–Stand hub
3. Bolt, 3/8 x 1–1/2 in.
4. Lock Nut, 3/8 in.
Install 100 Series Z–Stand Hub
1. Place the Z–Stand hub on the right front frame
as shown in figure 2.
Note: Make sure the Z–Stand hub assembly
is against the front caster housing.
2. Install Z–Stand hub to frame with 2 bolts
(
3/8 x 3–1/2 in.) and 2 lock nuts (3/8 in.)
(Fig. 2).
Note: Install bolts as shown in figure 2.