Toro Z Master 74902TE, Руководство оператора

Страница: 56 / 80

g010169
g010207
Figure 80
1. Hydraulic unit shrouds
6. Over each dipstick, remove the cover and the
bolt attached to the cover . Clean around each
dipstick and hydraulic unit (
Figure 81 ).
g012434
Figure 81
1. Cover 2. Bolt
7. Position the seat.
Brake Maintenance
Adjusting the Parking
Brake
Service Interval: After the first 100 hours
Every 500 hours thereafter
Note:
This procedure must be followed after the
first 100 hours or when a brake component has been
removed or replaced.
1. Drive the machine onto a level surface.
2. Disengage the blade-control switch (PTO), move
the motion control levers to the N
EUTRAL
-
LOCK
position, and engage the parking brake.
3. Shut off the engine, wait for all moving parts to
stop, and remove the key.
4. Raise the back of the machine and support the
machine with jack stands.
DANGER
Mechanical or hydraulic jacks may fail
to support machine and cause a serious
injury.
• Use jack stands when supporting
machine.
• Do not use hydraulic jacks.
5. Remove the rear tires from the machine.
6. Remove any debris from the brake area.
7. Rotate the drive-wheel release handle to
the released position; refer to
Using the
Drive-Wheel-Release Valves (page 32) .
8. Check to see if there is a visible gap between
the L-bracket and the linkage stop (
Figure 82 ).
56