Toro Z Master 74902TE, Руководство оператора

Страница: 51 / 80

g008943
Figure 67
1. ROPS knob (locked
position) 3. Roll bar in the upright
position
2. Pull the ROPS knob out,
and rotate it 90 degrees to
change the roll bar position 4. Roll bar in the folded
position
Adjusting the Tracking
1. Disengage the blade-control switch (PTO).
2. Drive to an open, flat area, and move the
motion-control levers to the N
EUTRAL
-
LOCK
position.
3. Move the throttle midway between F
AST
and
S
LOW
.
4. Move both motion-control levers forward until
they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If it tracks to the right, loosen the bolts and adjust
the left stop plate rearward on the left T-slot until
the machine tracks straight (
Figure 68 ).
7. If it tracks to the left, loosen the bolts and adjust
the right stop plate rearward on the right T-slot
until the machine tracks straight (
Figure 68 ).
8. Tighten the stop plate ( Figure 68 ).
g027340
Figure 68
Left control lever shown
1. Control lever 3. Stop plate
2. Bolt
Checking the Tire Pressure
Service Interval: Every 50 hours/Monthly (whichever
comes first)
Maintain the air pressure in the rear tires at 90 kPa
(13 psi). Uneven tire pressure can cause uneven cut.
Check the tires when they are cold to get the most
accurate pressure reading.
Note:
The front tires are semi-pneumatic tires and do
not require air pressure maintenance.
51