the lever, allow the reverse-indicator springs to
bring the levers back to neutral.
Note:
The wheels must stop turning or slightly
creep in reverse.
11.
Shut off the unit, remove the jumper wire from
the wire harness, and plug the connector into
the seat switch.
12.
Remove the jack stands.
13.
Raise the deck and install the height-of-cut pin.
14.
Check that the machine does not creep in
neutral with the park brakes disengaged.
Adjusting the
Motion-Control Damper
The top damper mounting bolt can be adjusted to
obtain a more desired motion-control lever resistance.
See
for mounting options.
g008620
Figure 90
Right Control Shown
1.
Torque the locknut to 23 N∙m (17 ft-lb). The bolt must
protrude past the end of the locknut after torquing.
2.
Most resistance (firmest feel)
3.
Damper
4.
Medium resistance (medium feel)
5.
Least resistance (softest feel)
Adjusting the Motion
Control Neutral-Lock Pivot
The flanged nut can be adjusted to obtain a more
desired motion-control lever resistance when moving
it to the N
EUTRAL
-
LOCK
position. See
for
adjustment options.
1.
Loosen the jam nut.
2.
Tighten or loosen the flanged nut to the desired
feel.
Note:
For more resistance, tighten the flanged
nut.
Note:
For less resistance, loosen the flanged
nut
3.
Tighten the jam nut.
g008621
Figure 91
1.
Flanged nut
2.
Jam nut
61
Содержание Z Master 74902TE
Страница 75: ...Schematics g009180 Wire Diagram Rev A 75...
Страница 76: ...Notes...
Страница 77: ...Notes...
Страница 78: ...Notes...