Toro Z MASTER 74310, Инструкции по установке

Страница: 9 / 12

Figure 17
9
Checking the Hydraulic Fluid
No Parts Required
Procedure
The machine is shipped with hydraulic oil in the reservoir.
1. Check and ensure the reservoir has hydraulic oil.
2. If needed add Toro HYPR-OIL™ 500 hydraulic oil.
3. Run the machine for approximately 15 minutes to allow
any extra air to purge out of the hydraulic system.
4. Wait until the unit cools before checking the hydraulic
oil.
5. Tilt the hopper up.
6. Remove the hydraulic reservoir cap.
7. Wipe the dipstick clean and insert the cap back into
the hydro.
8. Lightly tighten the cap.
9. Remove the cap again and check the level of the oil
on the dipstick (
Figure 18 ).
10. Check the hydraulic reservoir and if necessary fill
the reservoir to the appropriate level with Toro
HYPR-OIL™ 500 hydraulic oil.
Figure 18
1. Full 2. Add
11. If the dipstick oil level is at the Add mark, add hydraulic
oil. Do not overfill.
12. Replace the hydraulic reservoir cap and tighten until
snug. Do not overtighten.
10
Checking the Machine for
Grease
Parts needed for this procedure:
1 tube
Number 2 general-purpose lithium-base or
molybdenum-base grease. (Purchase separately.)
Procedure
Before you use the machine, check the machine for grease;
refer to Lubrication in the
Operator's Manual.
9