Toro Workman 2110, Руководство оператора

Страница: 13 / 44

Figure 8
1. Pivot bracket
3. Slide the cargo box mounting hole onto the pivot
bracket (Figure 9).
Figure 9
1. Cargo box 3. Cargo box mounting hole
2. Pivot bracket
4. Insert the right hand pivot bracket into the mounting
hole in the cargo box and then mount it to the frame.
5. Have another person help to raise the cargo box.
6. Loosen the bolt securing the prop rod clip to the
frame until you can slide the J-hook end of the prop
rod under the clip (Figure 10).
Figure 10
1. Prop rod
3. Bolt (5/16 x 3/4 inch)
2. Prop rod clip 4. Flange nut (5/16 inch)
7. Tighten the bolt and secure the other side of the clip
with a new bolt (5/16 x 3/4 inch) and flange nut
(5/16 inch) (Figure 10).
8. Lower the cargo box.
7
Activating the Battery
No Parts Required
Procedure
None
Note:
This procedure is only needed for Model No.
07277TC.
If the battery is not filled with electrolyte or activated, it
must be removed from the vehicle, filled with electrolyte,
and charged. Bulk electrolyte with 1.260 specific gravity
must be purchased from a local battery supply outlet.
1. Remove the battery hold-down and lift the battery
out of the battery base.
Battery electrolyte contains sulfuric acid which
is a deadly poison and causes severe burns.
• Do not drink electrolyte or allow it to contact
your skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber gloves
to protect your hands.
• Fill the battery where clean water is always
available for flushing the skin.
2. Remove the filler caps from the battery and slowly
fill each cell until electrolyte is just above the plates.
13