Toro Workman 07235, Руководство оператора

Страница: 43 / 60

Replacing the Fuses
There are 4 fuses in the electrical system. They are
located beneath the hood (
Figure 50 ).
Lift/gate (Open) 30 A
Horn/power point 20 A
Headlights 15 A
Machine fuse
10 A
g202997
Figure 50
1. Fuse block
2. Ground block
Maintaining the Headlights
Replacing the Bulbs
CAUTION
If you install a higher wattage bulb than the
system is designed for, you may damage the
12 V power supply, or at a minimum, blow the
fuse.
Always use the specified Toro LED bulb to
prevent this issue.
CAUTION
The bulbs become extremely hot when in
operation. Handling a hot bulb can cause
severe burns and personal injury.
Always allow enough time to for the bulbs
to cool before replacing them. Use care
whenever handling the bulbs.
Specification: See your Parts Catalog .
1. Disconnect the battery; refer to Disconnecting
the Battery (page 41) .
2. Open the hood.
3. Disconnect the electrical connector for the
harness from the connector of the lamp
assembly at the back of the headlight housing
(
Figure 51 ).
g036872
Figure 51
1. Headlight housing 3. Harness-electrical
connector
2. Lamp assembly
4. Rotate the lamp assembly 1/4 turn
counterclockwise and moving it rearward,
out of the headlight housing (
Figure 51 ).
5. Insert the new lamp assembly and headlight
housing and align the tabs in the lamp assembly
with the slots in the headlight housing (
Figure
51 ).
6. Secure lamp assembly by turning it 1/4 turn
clockwise (
Figure 51 ).
7. Connect the electrical connector for the harness
to the connector of the new lamp assembly
(
Figure 51 ).
8. Connect the battery and close the hood; refer to
Connecting the Battery (page 42) .
43