Toro Workman 07235, Руководство оператора

Страница: 38 / 60

Replacing the Carbon Canister
Note:
Replace the carbon canister if it is damaged,
plugged, or if the machine is run without a
carbon-canister filter.
Note:
Replace the carbon-canister filter when
replacing the carbon canister.
Disconnecting the Controls at the Seat Base
1. Remove the knob from the gear-shift lever
(
Figure 42 ).
g026304
Figure 42
1. Shifter plate 2. Gear-shift-lever knob
2. Remove the 4 bolts that secure the shifter plate
to the shifter bracket (
Figure 42 ).
3. Remove the 4 bolts that secure the shifter plate
to the seat base and remove the shifter plate
(
Figure 42 ).
Disconnecting the Parking-Brake Cable
1. At the bottom of the machine, remove the cable
tie that secures the parking-brake cable to the
service brake line (
Figure 43 ).
2. Mark a rotation stripe on the forward jam nut for
the parking-brake cable (
Figure 43 ).
Note:
Ensure that the forward-jam nut does
not rotate.
g029670
Figure 43
1. Cable tie 6. Front of the machine
2. Parking-brake cable
7. Clevis
3. Forward-jam nut 8. Cotter pin
4. Brake-cable bracket 9. Clevis pin
5. Rear-jam nut 10. Brake-actuating lever
3. Loosen the rear-jam nut and remove the cable
from the brake-cable bracket (
Figure 43 ).
4. Remove the cotter pin and the clevis pin that
secure the clevis for the parking-brake cable to
the brake-actuating lever and separate the cable
from the lever (
Figure 43 ).
5. Repeat steps 1 through 4 to the parking-brake
cable at the other side of the machine.
Removing the Seats and Seat Bases
1. At the bottom of the machine, remove the 8
flange-head bolts and 8 washers that secure the
seat base to the floor plate and rear-cab channel
(
Figure 44 ).
g029658
Figure 44
1. Flange-head bolt 4. Hole (floor plate)
2. Washer 5. Front of the machine
3. Hole (rear-cab channel)
38