Maintenance Service
Interval
Maintenance Procedure
Yearly
• Change the engine coolant (Authorized Service Dealer only).
• Change the engine coolant.
Yearly or before storage
• Check and adjust the track tension.
• Touch up chipped paint.
Every 2 years
• Drain and clean the fuel tank(s)—Authorized Service Dealer only.
• Replace all moving hydraulic hoses.
Pre-Maintenance
Procedures
Maintenance Safety
•
Park the machine on a level surface, disengage
the auxiliary hydraulics, lower the attachment,
engage the parking brake (if equipped), shut
off the engine, and remove the key. Wait for all
movement to stop and allow the machine to cool
before adjusting, cleaning, storing, or repairing it.
•
Clean up oil or fuel spills.
•
Do not allow untrained personnel to service the
machine.
•
Use jack stands to support the components when
required.
•
Carefully release pressure from components with
stored energy.
•
Disconnect the battery before making any repairs;
refer to
Using the Battery-Disconnect Switch (page
34)
.
•
Keep your hands and feet away from the moving
parts. If possible, do not make adjustments with
the engine running.
•
Keep all parts in good working condition and all
hardware tightened. Replace all worn or damaged
decals.
•
Do not tamper with the safety devices.
•
Use only Toro-approved attachments.
Attachments can change the stability and the
operating characteristics of the machine. You may
void the warranty if you use the machine with
unapproved attachments.
•
Use only genuine Toro replacement parts.
•
If any maintenance or repair requires the loader
arms to be in the raised position, secure the arms
in the raised position with the hydraulic-cylinder
lock(s).
Using the Cylinder Locks
WARNING
The loader arms may lower when in the raised
position, crushing anyone under them.
Install the cylinder lock(s) before performing
maintenance that requires raised loader arms.
Installing the Cylinder Locks
1.
Remove the attachment.
2.
Raise the loader arms to the fully raised position.
3.
Shut off the engine and remove the key.
4.
Remove the 2 pins securing the cylinder lock to
the posts on the side of the machine.
5.
Slide the cylinder lock over the lift-cylinder rod
(
).
g031214
Figure 31
1.
Cylinder lock
2.
Lift-cylinder rod
6.
Repeat step
and
for the other side of the
machine.
7.
Slowly
lower the loader arms until the cylinder
locks contact the cylinder bodies and rod ends.
25
Содержание TX 1000 Compact Tool Carrier
