Toro TX 1000 Compact Tool Carrier, Руководство оператора

Страница: 21 / 60

Removing an Attachment
1. Park the machine on a level surface.
2. Lower the attachment to the ground.
3. Shut off the engine and remove the key.
4. Disengage the quick-attach pins by turning them
to the outside.
5. If the attachment uses hydraulics, move the
auxiliary-hydraulics lever forward, backward,
and back to the N
EUTRAL
position to relieve
pressure at the hydraulic couplers.
6. If the attachment uses hydraulics, slide the
collars back on the hydraulic couplers and
disconnect them.
Important:
Connect the attachment hoses
together to prevent hydraulic system
contamination during storage.
7. Install the protective covers onto the hydraulic
couplers on the machine.
8. Start the engine, tilt the mount plate forward, and
back the machine away from the attachment.
After Operation
After Operation Safety
•
Shut off the engine, remove the key, wait for all
movement to stop, and allow the machine to cool
before adjusting, cleaning, storing, or servicing it.
•
Clean debris from the attachments, drives,
mufflers, and engine to help prevent fires. Clean
up oil or fuel spills.
•
Keep all parts in good working condition and all
hardware tightened.
•
Do not touch parts that may be hot from operation.
Allow them to cool before attempting to maintain,
adjust, or service the machine.
•
Use care when loading or unloading the machine
into a trailer or truck.
Moving a Non-Functioning
Machine
Important:
Do not tow or pull the machine
without first opening the tow valves, or you will
damage the hydraulic system.
1. Shut off the engine and remove the key.
2. Open the hood and secure the hood prop.
3. Remove the side screens; refer to Removing the
Side Screens (page 27) .
4. Using a wrench, turn the tow valves on the
hydraulic pumps twice counterclockwise (
Figure
26 ).
g031210
g031211
Figure 26
1. Tow valve
5. Tow the machine as required.
6. After repairing the machine, close the tow valves
before operating it.
Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Use a full-width ramp. Ensure that the trailer
or truck has all the necessary brakes, lighting, and
marking as required by law. Please carefully read all
the safety instructions. Knowing this information could
help you or bystanders avoid injury. Refer to your
local ordinances for trailer and tie-down requirements.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents causing personal
injury.
Do not drive the machine on a public street
or roadway.
21