Toro TimeCutter MX 4275T, Руководство пользователя

Страница: 31 / 240

g027996
Figure 32
1. Full-width ramp in stowed
position 4. Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground
2. Side view of full-width
ramp in loading position 5. H=height of the trailer or
truck bed to the ground
3. Not greater than
15 degrees 6. Trailer
Loading the Machine
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death.
• Use extreme caution when operating a
machine on a ramp.
• Back the machine up the ramp and drive it
forward down the ramp.
• Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
1. If you are using a trailer, connect it to the towing
vehicle and connect the safety chains.
2. If applicable, connect the trailer brakes and
lights.
3. Lower the ramp, ensuring that the angle
between the ramp and the ground does not
exceed 15 degrees (
Figure 32 ).
4. Back the machine up the ramp ( Figure 33 ).
g027995
Figure 33
1. Back the machine up the
ramp. 2. Drive the machine forward
down the ramp.
5. Shut off the engine, remove the key, and move
the motion-control levers outward to the P
ARK
position.
6. Tie down the machine near the front caster
wheels and the rear frame with straps, chains,
cable, or ropes (
Figure 34 ). Refer to local
regulations for tie-down requirements.
g027708
Figure 34
1. Tie-down points
Unloading the Machine
1. Lower the ramp, ensuring that the angle
between the ramp and the ground does not
exceed 15 degrees (
Figure 32 ).
2. Drive the machine forward down the ramp
(
Figure 33 ).
29