Toro TimeCutter HD X4850, Руководство оператора

Страница: 27 / 56

drop onto your lawn. To avoid this, move onto a
previously cut area with the blades engaged or you
can disengage the mower deck while moving forward.
Keeping the Underside of the
Mower Deck Clean
Clean clippings and dirt from the underside of the
mower deck after each use. If grass and dirt build up
inside the mower deck, cutting quality will eventually
become unsatisfactory.
Maintaining the Blade(s)
Maintain a sharp blade throughout the cutting season
because a sharp blade cuts cleanly without tearing or
shredding the grass blades. Tearing and shredding
turns grass brown at the edges, which slows growth
and increases the chance of disease. Check the
mower blades after each use for sharpness, and
for any wear or damage. File down any nicks and
sharpen the blades as necessary. If a blade is
damaged or worn, replace it immediately with a
genuine Toro replacement blade.
After Operation
After Operation Safety
General Safety
•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
Shut off the fuel before storing or transporting the
machine.
•
Disengage the drive to the attachment whenever
you are transporting or not using the machine.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Pushing the Machine by
Hand
Important:
Always push the machine by hand.
Do not tow the machine, because towing may
damage it.
This machine has an electric-brake mechanism,
and to push the machine, the key must be in the
RUN
position. The battery needs to be charged and
functioning to disengage the electric brake.
Pushing the Machine
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Locate the bypass levers on the frame on both
sides of the engine.
4. Move the bypass levers forward through the key
hole and down to lock them in place (
Figure 36 ).
Note:
Do this for each lever.
5. Turn the ignition key on and disengage the
parking brake.
Note:
Do not start the machine.
27