Pushing the Machine by Hand
Important:
Always push the machine by hand. Do not
tow the machine, because damage may occur.
This machine has an electric-brake mechanism. To push the
machine, the ignition key needs to be in the
RUN
position.
The battery needs to be charged and functioning for the
electric brake to be disengaged.
Pushing the Machine
1.
Park the machine on a level surface and disengage the
blade-control switch.
2.
Set the parking brake, shut off the engine, and wait for
all moving parts to stop before leaving the operating
position.
3.
Locate the bypass levers on the frame on both sides of
the engine.
4.
Move the bypass levers forward through the key hole
and down to lock them in place (
5.
Turn the ignition key to the O
N
position and disengage
the parking brake.
Note:
Do not start the machine.
g017303
1 2
3
Figure 17
1.
Bypass-lever locations
3.
Lever position for pushing
the machine
2.
Lever position for
operating the machine
6.
When you are finished pushing the machine, return the
key to the
STOP
position to avoid draining the battery
charge.
Note:
If the machine fails to move, the electric brake may
still be engaged. If necessary, the electric brake can be released
manually; refer to
Releasing the Electric Brake (page 35)
.
Operating the Machine
Move the bypass levers rearward through the key hole and
down to lock them in place as shown in
Note:
Ensure that the bypass levers are pull rearward the full
length of travel.
Using the Grass Deflector
The mower has a hinged grass deflector that disperses
clippings to the side and down toward the turf.
DANGER
Without the grass deflector, discharge cover, or
complete grass catcher assembly mounted in
place, you and others are exposed to blade contact
and thrown debris. Contact with rotating mower
blade(s) and thrown debris causes injury or death.
•
Never remove the grass deflector from
the mower, because the grass deflector
routes material down toward the turf. If the
grass deflector is ever damaged, replace it
immediately.
•
Never put your hands or feet under the mower.
•
Never try to clear discharge area or mower
blades unless you move the blade-control switch
to the O
FF
position and rotate the ignition key
to O
FF
position. Also remove the key and pull
the wire off the spark plug(s).
21
Содержание TimeCutter 74780
Страница 47: ...Schematics Electrical Diagram Rev A 47 ...