Figure 57
1.
Washout fitting
3.
O-ring
2.
Hose
4.
Coupling
4.
Lower the mower to the lowest height of cut.
5.
Sit on the seat and start the engine. Engage the
blade-control switch and let the mower run for 1 to 3
minutes.
6.
Disengage the blade-control switch, shut off the
engine, and remove the ignition key. Wait for all
moving parts to stop.
7.
Turn the water off and remove the coupling from the
washout fitting.
Note:
If the mower is not clean after 1 washing, soak it
and let it stand for 30 minutes. Then repeat the process.
8.
Run the machine and mower blades again for 1 to 3
minutes to remove excess water.
9.
Turn off the mower blades.
WARNING
A broken or missing washout fitting could
expose you and others to thrown objects or
blade contact. Contact with a blade or thrown
debris can cause injury or death.
•
Replace broken or missing washout fitting
immediately, before using mower again.
•
Never put your hands or feet under the
mower or through openings in the mower.
Storage
Cleaning and Storage
1.
Disengage the blade-control switch, shut off the
engine, and remove the key.
2.
Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine cylinder head fins and blower housing.
Important:
You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, under the seat, around the
engine, hydraulic pumps, and motors.
3.
Service the air cleaner; refer to
.
4.
Grease and oil the machine; refer to
Lubrication (page
.
5.
Change the crankcase oil and filter; refer to
the Engine Oil and Filter (page 28)
.
6.
Check the tire pressure; refer to
.
7.
Charge the battery; refer to
Charging the Battery (page
.
8.
Check the condition of the blades; refer to
the Cutting Blades (page 35)
.
9.
Prepare the machine for storage when non-use occurs
over 30 days. Prepare the machine for storage as
follows.
10.
Add a petroleum based stabilizer/conditioner to the
fuel in the tank. Follow the mixing instructions from
the stabilizer manufacturer. Do not use an alcohol
based stabilizer (ethanol or methanol).
Note:
A fuel stabilizer/conditioner is most effective
when mixed with fresh gasoline and used at all times.
Run the engine to distribute the conditioned fuel
through the fuel system (5 minutes).
Important:
Do not store gasoline with
stabilizer/conditioner over 90 days.
11.
Remove the spark plug(s) and check its condition; refer
to
Checking the Spark Plug (page 31)
. With the spark
plug(s) removed from the engine, pour 2 tablespoons
of engine oil into the spark plug hole. Use the starter
to crank the engine and distribute the oil inside the
cylinder. Install the spark plug(s). Do not install the
wire on the spark plug(s).
12.
Clean any dirt and chaff from the top of the mower.
13.
Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
14.
Check the condition of the drive and mower belts.
43
Содержание TimeCutter 74780
Страница 47: ...Schematics Electrical Diagram Rev A 47 ...
