Toro TimeCutter 74750, Руководство оператора

Страница: 40 / 48

G014634
1
2
3
Figure 55
1. Adjusting rod 3. Locknut
2. Adjusting block
7. To raise the front of the mower, tighten the adjustment
nut.
8. To lower the front of the mower, loosen the adjustment
nut.
9. After adjustment, check the front-to-rear slope again.
Continue adjusting the nut until the front blade tip is
1.6-7.9 mm (1/16-5/16 inch) lower than the rear blade
tip (
Figure 54 ).
10. When the front-to-rear blade slope is correct check the
side-to-side level of the mower again; refer to
Leveling
Side-to-Side (page 38) .
Removing the Mower
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the P
ARK
position, shut off the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest position.
4. Remove the hairpin cotter from the front support rod,
and remove the rod from the deck bracket (
Figure 56 ).
Note:
Carefully lower the front of the mower deck
to the ground.
G014635
1
2
3
Figure 56
1. Front support rod 3. Deck bracket
2. Locking nut
5. Using the mower deck handles, lift the mower deck and
hanger brackets clear of the rear lift rod and lower the
mower carefully to the ground (
Figure 57 ).
2
2
3
G005077
1
2
2
3
Figure 57
1. Mower deck 3. Rear lift rod
2. Hanger bracket
6. Slide the mower deck rearward to remove the mower
belt from the engine pulley.
7. Slide the mower deck out from underneath the
machine.
Note:
Retain all parts for future installation.
40