Toro TimeCutter 5000C, Руководство оператора

Страница: 23 / 56

Driving the Machine
The drive wheels turn independently, powered by
hydraulic motors on each axle. You can turn 1 side
in reverse while you turn the other forward, causing
the machine to spin rather than turn. This greatly
improves the machine maneuverability but may
require sometime for you to adapt to how it moves.
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place
the throttle control in the F
AST
position for best
performance. Always operate in the full throttle
position when mowing.
WARNING
The machine can spin very rapidly. You
may lose control of the machine and cause
personal injury or damage to the machine.
• Use caution when making turns.
• Slow the machine down before making
sharp turns.
Driving Forward
Note:
Always use caution when backing up and
turning.
1. Move the levers to the center, unlocked position.
2. To go forward, slowly push the motion-control
levers forward (
Figure 22 ).
g008952
Figure 22
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion-control
levers rearward (
Figure 23 ).
g008953
Figure 23
Using the Smart Speed TM
Control System
The Smart Speed TM Control-System lever, located
below the operating position ( Figure 24 ), gives the
operator a choice to drive the machine at 3 ground
speed ranges—trim, tow, and mow.
g293338
Figure 24
1. Smart-speed lever
To change speeds, do the following:
1. Move the motion-control levers to neutral and
outward to the P
ARK
position.
23