Toro TimeCutter 5000C, Руководство оператора

Страница: 32 / 56

Pre-Maintenance
Procedures
Raising the Machine
Use jackstands to support the machine when you
raise it.
WARNING
Supporting the machine on the lower muffler
shield (
Figure 31 ) may damage the shield and
cause the machine to fall, injuring you or
bystanders.
Do not use the lower muffler shield to support
the machine.
g299647
Figure 31
1. Lower muffler shield
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease the caster
wheel bearings.
Grease Type: No. 2 lithium grease
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
ARK
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings ( Figure 32 ) with a rag.
Note:
Scrape any paint off the front of the
fitting(s).
g032432
Figure 32
1. Front caster tire
4. Connect a grease gun to each fitting ( Figure 32 ).
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
6. Wipe up any excess grease.
32