Toro SprayMaster 34246, Руководство оператора

Страница: 46 / 64

Important:
Do Not operate the engine with the
oil level below the “LOW” (or “ADD”) mark on the
dipstick, or over the “FULL” mark.
Change Engine Oil
Service Interval: After the first 5 hours
Every 100 hours/Yearly (whichever comes first)
(May need more often under severe conditions.)
1. Stop engine, wait for all moving parts to stop,
and remove key. Engage parking brake.
2. Drain oil while engine is warm from operation.
3. Remove dip stick. The oil drain plug and hose
are located at the back of the machine on the
left side.
Place pan under machine to catch oil. Remove
drain oil plug to open and allow oil to drain and
reinstall plug when complete.
4. Replace the oil filter every other oil change,
which is located at the back of the machine
under a shield. Clean around oil filter and
unscrew filter to remove. Before reinstalling
new filter, apply a thin coating of Toro 4–Cycle
Premium Engine oil on the surface of the rubber
seal. Turn filter clockwise until rubber seal
contacts the filter adapter then tighten filter an
additional 1/2 to 3/4 turn.
5. Clean around oil fill cap and remove cap. Fill to
specified capacity and replace cap.
6. Use oil recommended in the Check Engine Oil
Level section. Do Not overfill. Start the engine
and check for leaks. Stop engine and recheck
oil level.
7. Wipe up any spilled oil from engine deck
mounting surfaces.
Check Spark Plugs
Service Interval: Every 100 hours/Yearly (whichever
comes first)
Remove spark plugs, check condition and reset gaps,
or replace with new plugs. See Engine Owner's
Manual.
Fuel System
Maintenance
Check Fuel Filter and Tank
Service Interval: Before each use or daily
1. Stop engine, wait for all moving parts to stop,
and remove key. Engage parking brake.
2. Check the fuel filter and tank for leaks. See
Engine Owner's Manual.
46