Toro SprayMaster 34246, Руководство оператора

Страница: 41 / 64

After Operation
After Operation Safety
General Safety
•
Park machine on level ground, disengage drives,
set parking brake, stop engine, and remove key.
Wait for all moving parts to stop before leaving
the operator’s position. Allow the machine to cool
before servicing, adjusting, fueling, unclogging,
cleaning, or storing.
•
Clean grass, leaves, excessive grease or oil, and
other debris from the muffler, drives, and engine
area to help prevent fires.
•
Close the fuel shut-off valve before storing or
transporting the machine.
Transporting
Note:
Refer to the chemical warning product
label(s) before transporting the machine and follow
all local/state/federal requirements for transporting
chemicals.
Note:
Make sure the spreader hopper cover and the
spray wand are secure before transporting.
Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
necessary lighting and marking as required by law.
Thoroughly read all of the safety instructions. Knowing
this information could help you, your family, pets, or
bystanders avoid injury.
To transport the machine:
•
Lock the brake and block the wheels.
•
Securely fasten the machine to the trailer or
truck with straps, chains, cable, or ropes. When
securing the front of the machine, only use the tie
down locations shown in
Figure 40 . If possible,
both front and rear straps should be directed
down and outward from the machine. Using
non-designated locations may cause damage to
the machine and/or attachment.
g397874
Figure 40
1. Tie down location
WARNING
Securing the machine on any upper frame
location will cause the parking brake to
not function properly, which could cause
serious injury or death.
Only use the front tie down locations on
the lower frame to secure the machine.
•
Secure a trailer to the towing vehicle with safety
chains.
WARNING
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow
moving vehicle emblem is dangerous and can
lead to accidents causing personal injury.
Do not drive machine on a public street or
roadway.
Loading the Machine
Use extreme caution when loading machines
on trailers or trucks. One full width ramp that is
wide enough to extend beyond the rear tires is
recommended instead of individual ramps for each
side of the machine. A full width ramp provides a
surface to walk on behind the machine. If it is not
possible to use one full width ramp, use enough
individual ramps to simulate a full width continuous
ramp.
A steep ramp angle may cause components to get
caught as the machine moves from ramp to trailer or
truck. Steeper angles may also cause the machine to
tip backward. If loading on or near a slope, position
the trailer or truck so it is on the down side of the
slope and the ramps extends up the slope. This will
minimize the ramp angle. The trailer or truck should
be as level as possible.
Important:
Do Not attempt to turn the machine
while on the ramp, you may lose control and drive
off the side.
41