Toro Reelmaster 5610-D, Руководство пользователя

Страница: 66 / 84

Drive System Maintenance
Checking the Tire Air Pressure
Service Interval: Before each use or daily
Important:
Maintain the recommended pressure in
all tires to ensure a good quality of cut and proper
machine performance. Do not underinflate the tires.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 52) .
2. Measure the tire air pressure.
Note:
The correct air pressure in the tires is 83 to
103 kPa (12 to 15 psi).
3. If needed add air to or remove air from the tire.
4. Repeat steps 2 and 3 at the other tires.
Checking the Torque of the Wheel Nuts
Service Interval: After the first hour
After the first 10 hours
Every 250 hours
WARNING
Failure to maintain proper torque of the wheel nuts
could result in personal injury.
Maintain the proper torque on the wheel nuts.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 52) .
2. Torque the wheel nuts to 94 to 122 N∙m (70 to 90 ft-lb).
Adjusting the Traction Drive for Neutral
Important:
The machine must not move when the
traction pedal is released (in the N
EUTRAL
position). If
the machine moves, adjust traction pump as follows:
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 52) .
2. Jack up the front of the machine until the both front
tires are off the ground, and support the machine with
jack stands, refer to
Specifications (page 29) and
Jacking Point Locations (page 54) .
3. From the bottom of the machine and at the right side
of the traction pump, loosen the locknut that secures
the neutral return-adjustment screw (
Figure 136 ).
g375898
Figure 136
1. Neutral return-adjustment
screw 3. Traction pump
2. Locknut
WARNING
The engine must be running so the final
adjustment of the traction adjustment cam can be
performed. This could cause personal injury.
Keep hands, feet, face, and other body parts away
from the muffler, other hot parts of the engine,
and any rotating parts.
4. Start the engine and release the parking brake.
5. Rotate the neutral return-adjustment screw in either
direction until the wheels stop rotating.
6. Torque the locknut to 22 N∙m (16 ft-lb).
7. Shut off the engine and remove the key.
8. Remove the jack stands, and lower the machine to
the ground.
9. Test drive the machine to ensure that it does not move
when the traction pedal is in the N
EUTRAL
position.
66