Toro Reelmaster 3555, Руководство оператора, Страница: 58 / 76

Controls System
Maintenance
Adjusting Mow Ground
Speed
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 41) .
2. Loosen the jam nut for the speed stop screw.
3. Adjust the speed stop screw as follow:
Note:
The mow speed is set at the factory to
9.7 km/h (6 mph).
•
To decrease the mow speed, rotate the
speed stop screw (
Figure 89 ) clockwise.
•
To increase the mow speed, rotate the speed
stop screw counterclockwise.
g352075
Figure 89
1. Speed stop screw
4. Hold the stop screw and tighten the jam nut.
5. Test drive the machine to confirm the maximum
mow speed adjustment.
Adjusting the Throttle
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 41) .
2. Unlatch and open the hood.
3. Position the throttle lever rearward so that it
stops against the control panel slot.
4. Loosen the throttle cable connector on the
injection pump lever arm (
Figure 90 ).
g020336
Figure 90
1. Injection pump lever arm
5. Hold the injection pump lever arm against the
low idle stop and tighten the cable connector.
6. Loosen the screws securing the throttle control
to the control panel.
7. Push the throttle control lever all the way
forward.
8. Slide the stop plate until it contacts the throttle
lever and tighten the screws securing the throttle
control to the control panel.
9. If the throttle does not stay in position during
operation, torque the locknut, used to set the
friction device on the throttle lever, to 5 to 6 N∙m
(44 to 53 in-lb).
Note:
The maximum force required to operate
the throttle lever should be 89 N (20 lb).
10. Close and latch the hood.
58