Toro Reelmaster 03485, Руководство оператора

Страница: 5 / 24

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
Cutting unit 1 Inspect the cutting unit.
2
No parts required
–
Use the kickstand when tipping the
cutting unit.
3
No parts required
–
Adjust the rear shield.
Straight grease fitting 1
O-ring 1
4
Screws 2
Install the loose parts.
Media and Additional Parts
Description Qty. Use
Operator's Manual 1
Parts Catalog (not included)—refer to the
included postcard for information on obtaining
the Parts Catalog
–
Review the material and save it in an appropriate place.
Note:
Determine the left and right sides of the
machine from the normal operating position.
1
Inspecting the Cutting Unit
Parts needed for this procedure:
1 Cutting unit
Procedure
After the cutting unit is removed from the box, inspect
the following:
1. Check each end of the reel for grease.
Note:
Grease should be visibly evident in the
internal splines of the reel shaft.
2. Ensure that all nuts and bolts are securely
tightened.
3. Make sure that the suspension of the carrier
frame operates freely and does not bind when
moved back and forth.
2
Using the Kickstand
No Parts Required
Procedure
Whenever the cutting unit has to be tipped to expose
the bedknife/reel, prop up the rear of the cutting unit
with the kickstand (supplied with the traction unit) to
make sure that the nuts on the back end of the bedbar
adjusting screws are not resting on the work surface
(
Figure 3 ).
5