Toro Reelmaster 03485, Руководство оператора

Страница: 6 / 24

g027165
Figure 3
1. Kickstand
3
Adjusting the Rear Shield
No Parts Required
Procedure
Under most conditions, you can attain the best
dispersion when the rear shield is closed (front
discharge). When conditions are heavy or wet, you
can open the rear shield.
To open the rear shield ( Figure 4 ), loosen the bolt
securing the shield to the left side plate, rotate the
shield to the open position, and tighten the bolt.
g031243
Figure 4
1. Bolt 2. Rear shield
4
Installing the Loose Parts
Parts needed for this procedure:
1 Straight grease fitting
1 O-ring
2 Screws
Procedure
Install the grease fitting on the reel-motor side of the
cutting unit. Use
Figure 5 to determine the position
of the reel motors.
g031275
Figure 5
1. Cutting unit 1 5. Cutting unit 5
2. Cutting unit 2 6. Reel motor
3. Cutting unit 3 7. Weight
4. Cutting unit 4
1. Remove and discard the set screw on the
reel-motor side plate (
Figure 6 ).
g031255
Figure 6
1. Bolt (2) 3. Grease fitting
2. Set screw 4. Grease vent
2. Install the straight grease fitting ( Figure 6 ).
3. If there are no bolts on the reel-motor side plate,
install them (
Figure 6 ).
6