Toro Recycler 22275, Руководство оператора

Страница: 25 / 272

Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 25 hours
• Tighten any loose fasteners.
Before each use or daily
• Inspect the mower blades for wear or damage.
• Inspect the accelerator for wear or damage.
• Check the stopping time of the blade brake. The blade must stop within 3 seconds
of releasing the blade-control bar; if it does not, contact an Authorized Service
Dealer for repair.
After each use
• Clean the underside of the machine.
Every 40 hours
• Clean the wheels and gears.
Every 50 hours
• Sharpen or replace the blade. Maintain it more frequently if the edge dulls quickly in
rough or in sandy conditions.
Every 100 hours
• Tighten any loose fasteners.
Adjusting the Self-Propel
Drive
If the machine is new, does not self-propel, or it tends
to creep forward, adjust the drive cable.
1. Move the machine outside and onto a paved
surface near a solid wall to safely prevent the
machine from moving forward while the motor
is turned on.
2. Position the machine with the front tires against
the wall.
Note:
Ensure that the area is well ventilated
and clear of debris that could be thrown by the
machine.
3. Start the motor; refer to Starting the Machine
(page 17) .
4. Pull the self-propel-drive bar to the handle.
Note:
The wheels should start to turn as the
self-propel-drive bar just touches the handle.
5. Shut off the motor.
6. If you must adjust the machine, do the following:
•
If the wheels do not spin when you engage
the self-propel-drive bar, the traction belt is
too loose. Rotate the wheel-drive-control
knob (
Figure 22 ) clockwise 1 turn and repeat
steps 3 through 5 .
g024465
Figure 22
1. Wheel-drive-control knob
•
If the wheels spin before you fully engage
the self-propel-drive bar, the traction belt
is too tight. Rotate the wheel-drive-control
knob (
Figure 22 ) counterclockwise 1 turn
and repeat steps 3 through 5 .
7. For a new traction belt, rotate the
drive-cable-adjustment knob clockwise 1
additional turn to allow for the normal stretching
of the belt during the break-in period.
Note:
You can skip this step if you are adjusting
a used belt.
23