Toro Recycler 22275, Руководство оператора

Страница: 10 / 272

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
Mounting hardware (not included) 2 Mount the battery charger (optional).
2
No parts required
–
Remove the cable guard.
Upper handle assembly 1
Lower handle 2
Bolt (5/16 x 1-3/4 inches) 4
Flange locknut (5/16 inch) 4
3
Curved washer
8
Assemble the lower handle.
4
No parts required
–
Install the handle.
5
No parts required
–
Install the cable guard.
6
No parts required
–
Assemble the grass bag.
Important:
Remove and discard the protective
plastic sheet that covers the motor and any other
plastic or wrapping on the machine.
Important:
The battery pack is not fully charged
when it is purchased. Before using the machine
for the first time, refer to
Charging the Battery
Pack (page 21) .
1
Mounting the Battery
Charger (Optional)
Parts needed for this procedure:
2 Mounting hardware (not included)
Procedure
If desired, mount the battery charger securely on a
wall using the wall-mount key holes on the back of
the charger.
Mount it indoors (such as a garage or other dry place),
near a power outlet, and out of the reach of children.
Refer to Figure 3 for assistance in mounting the
charger.
Slide the charger over the appropriately positioned
hardware to secure the charger in place (hardware
not included).
g290534
Figure 3
8