Toro Recycler 20332, Руководство оператора

Страница: 19 / 72

Cleaning under the Machine
Service Interval: Before each use or daily
WARNING
The machine may dislodge material from under the
machine.
• Wear eye protection.
• Stay in the operating position (behind the
handle) when the engine is running.
• Do not allow bystanders in the area.
For best results, clean the machine soon after you have
completed mowing.
1. Move the machine onto a flat paved surface.
2. Stop the engine and wait for all moving parts to stop
before leaving the operating position.
3. Lower the machine to its lowest cutting-height setting;
refer to
Adjusting the Cutting Height (page 8) .
4. Wash out the area under the rear deflector where the
clippings go from the housing to the grass bag.
Note:
Wash out the area with the bag-on-demand in
both the fully forward and fully rearward positions.
5. Attach a garden hose that is connected to a water
supply to the washout port (
Figure 32 ).
Figure 32
1. Washout port
6. Turn the water on.
7. Start the engine and run it until there are no more
clippings that come out from under the machine.
8. Stop the engine.
9. Shut off the water and disconnect the garden hose
from the machine.
10. Start the engine and run it for a few minutes to dry the
underside of the machine to prevent it from rusting.
11. Allow the engine to cool before storing the machine
in an enclosed area.
Storage
Store the machine in a cool, clean, dry place.
Preparing the Machine for
Storage
WARNING
Gasoline vapors can explode.
• Do not store gasoline more than 30 days.
• Do not store the machine in an enclosure near
an open flame.
• Allow the engine to cool before storing it.
1. On the last refueling of the year, add fuel stabilizer to
the fuel as directed by the engine manufacturer.
2. Dispose of any unused fuel properly. Recycle it
according to local codes, or use it in your automobile.
Note:
Old fuel in the fuel tank is the leading cause of
hard starting. Do not store fuel without stabilizer more
than 30 days, and do not store stabilized fuel more than
90 days.
3. Run the machine until the engine stops from running
out of fuel.
4. Start the engine again.
5. Allow the engine to run until it stops. When you can
no longer start the engine, it is sufficiently dry.
6. Disconnect the wire from the spark plug.
7. Remove the spark plug, add 30 ml (1 oz) of oil through
the spark-plug hole, and pull the starter rope slowly
several times to distribute oil throughout the cylinder
to prevent cylinder corrosion during the off-season.
8. Loosely install the spark plug.
9. Tighten all nuts, bolts, and screws.
10. Charge the battery for 24 hours, then unplug the
battery charger an store the machine in an unheated
area. If you must store the machine in a heated area,
you must charge the battery every 90 days (electric-start
model only).
Remove the Machine from
Storage
1. Check and tighten all fasteners.
2. Remove the spark plug and spin the engine rapidly
by pulling the recoil-start handle or using the electric
19