Toro Recycler 20332, Руководство оператора

Страница: 15 / 72

WARNING
Tipping the machine may cause the fuel to leak.
Gasoline is flammable and explosive and can cause
personal injury.
Run the engine dry or remove the gasoline with a
hand pump; never siphon.
Servicing the Air Filter
Service Interval: Every 25 hours
1. Upclip the top of the air-filter cover ( Figure 22 ).
Figure 22
1. Clip 3. Air filter
2. Air-filter cover
2. Remove the air filter ( Figure 22 ).
3. Inspect the air filter.
Note:
If the air filter is excessively dirty, replace it with
a new filter. Otherwise, gently tap the air filter on a
hard surface to loosen debris.
4. Install the air filter.
5. Use the clip to install the air-filter cover.
Changing the Engine Oil
Changing the engine oil is not required, but if you desire
to change the oil, use the following procedure.
Note:
Run the engine a few minutes before changing the
oil to warm it. Warm oil flows better and carries more
contaminants.
Max. fill: 0.53 L (18 oz), type: SAE 30 detergent oil with an
API service classification of SF, SG, SH, SJ, SL, or higher.
1. Refer to Preparing for Maintenance (page 14) .
2. Remove the dipstick ( Figure 23 ).
Figure 23
1. Dipstick
3. Tip the machine onto its side with the air filter up to
drain the used oil out through the oil-fill tube (
Figure
24 ).
Figure 24
4. Slowly pour oil into the oil-fill tube until the oil level
reaches the Full line on the dipstick ( Figure 23 ). Do
not overfill.
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
15