Toro Recycler 20331, Руководство оператора

Страница: 5 / 40

2
Filling the Engine with Oil
No Parts Required
Procedure
Important:
Your mower does not come with oil in the
engine, but it does come with a bottle of oil. Before
starting the engine, fill the engine with oil.
Max. fill: 20 oz. (0.59 l), type: SAE 30 detergent oil with an
API service classification of SF, SG, SH, SJ, SL, or higher.
Note:
When the crankcase is empty, pour about 3/4 of
the crankcase capacity of oil in the crankcase, then do the
following:
1. Move the mower to a level surface.
2. Remove the dipstick (Figure 4).
Figure 4
1. Dipstick
3. Slowly pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 4). Wait
3 minutes after adding oil to check the oil level with
the dipstick. Do not overfill. (Max. fill: 20 oz. (0.59
l), type: SAE 30 detergent oil with an API service
classification of SF, SG, SH, SJ, SL, or higher.)
Important:
Do not overfill the crankcase with oil
and run the engine. Drain the excess oil until the
oil level on the dipstick reads Full.
4. Install the dipstick securely.
Important:
Change the engine oil after the first 5
operating hours ; change it yearly thereafter. Refer
to (page ).
Product Overview
Figure 5
1. Cutting height lever (4) 7. Recoil start handle
2. Spark plug 8. Blade control bar
3. Air filter (not shown) 9. Self-propel drive bar
4. Fuel tank cap 10. Handle knob (2)
5. Oil fill/dipstick 11. Washout port
6. Handle
Figure 6
1. Grass bag 2. Side discharge chute
5