Toro Recycler 20331, Руководство оператора

Страница: 8 / 40

Figure 11
To disengage the self-propel drive, release the self-propel
drive bar.
Note:
The maximum self-propel ground speed is fixed. To
reduce the ground speed, increase the space between the
self-propel drive bar and the handle.
Stopping the Engine
To stop the engine, release the blade control bar.
Note:
Remove the ignition key when you leave the mower
(electric-start models only).
Important:
When you release the blade control bar,
both the engine and blade should stop within 3 seconds.
If they do not stop properly, stop using your mower
immediately and contact an Authorized Service Dealer.
Recycling the Clippings
Your mower comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the grass bag is on the mower, remove it (refer to
Removing the Grass Bag (page 9)) before recycling the
clippings. If the side discharge chute is on the mower, remove
it (refer to Removing the Side Discharge Chute (page 10))
before recycling the clippings.
Bagging the Clippings
Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
Note:
Ensure that the bag is seated in the correct position.
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
If the side discharge chute is on the mower, remove it (refer
to Removing the Side Discharge Chute (page 10)) before
bagging the clippings.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Grass Bag
Note:
Ensure that the bag is seated in the correct position.
1. Raise and hold up the rear deflector (Figure 12).
8