Toro ProLine 30441, Руководство оператора, Страница: 28 / 64

28
1. To adjust, remove hairpin cotter from height-of-cut
post (Fig. 24).
2
1
3
m-4856
4
m–5230
2
4
1
5
Figure 24
1. Carrier Frame
2. Hairpin Cotter
3. Front height–of–cut post
4. Spacers
5. Back height–of–cut post
2. Select hole in height-of-cut post corresponding to the
height-of-cut desired (Fig. 24).
3. Lift on side of deck and remove hairpin cotter
(Fig. 24).
4. Add or remove spacers if needed and then align holes
and insert hairpin cotter (Fig. 24).
Note: Spare height–of–cut spacers may be stored on posts
and retained by a hairpin cotter.
Important All four hairpin cotter pins must be in the
same hole location and with the correct number of spacers
for a level cut.
Adjusting the Gage Wheels
The gage wheels need to be adjusted in the proper hole
location for each height-of-cut position. There needs to be
3/8 inch (10 mm) minimum clearance above the ground.
1. After adjusting height-of-cut, check the gage wheels so
that there is a minimum of 3/8 inch (10 mm) clearance
above the ground (Figures 25, 26, and 27).
2. If adjustment is needed, remove the bolt, washer(s)
and nut (Figures 25, 26, and 27).
3. Select a hole position so the gage wheels are a
minimum of 3/8 inch (10 mm) off the ground
(Figures 25, 26, and 27).
4. Install the bolt, washer(s) and nut (Figures 25, 26,
and 27).
1
3
m–6471
2
Figure 25
1. Gage wheel
2. Nut
3. Washer
m–6470
2
4
3
5
1
Figure 26
1. Gage wheel
2. Nut
3. Bolt
4. Washer
5. Spacer