Toro ProLine 20 HP 30611, Руководство оператора

Страница: 25 / 48

Maintenance
23
Engine Oil
Service Interval/Specification
Change oil:
•
After the first 8 operating hours.
•
After every 50 operating hours.
Note: Change oil more frequently when
operating conditions are extremely
dusty or sandy.
Oil Type: Detergent oil (API service SF, SE/CC, CD
or SE)
Crankcase Capacity: w/filter, .94 l (4 pints)
Viscosity: See table below
F
–20 0 20 40 60 80 100
°
C
–30
°
–20 –10 0 10 20 30 40
USE THESE SAE VISCOSITY OILS
32
Checking Oil Level
1. Raise seat and remove belt guard. See Removing
Belt Guard on page 21.
2. Park the machine on a level surface, disengage
the power take off (PTO), set the parking brake,
and turn the ignition key to “OFF” to stop the
engine. Remove the key.
3. Clean around the oil dipstick and oil fill
(Fig. 16) so dirt cannot fall into the filler hole
and damage the engine.
4. Pull the oil dipstick out and wipe the metal end
clean (Fig. 16).
5. Slide the oil dipstick fully into the dipstick tube
(Fig. 16). Pull the dipstick out and look at the
metal end. If oil level is low, slowly pour only
enough oil into the filler hole to raise the level to
the “FULL” mark.
IMPORTANT: Do not overfill the crankcase
with oil because the engine may be damaged.
6. Reinstall belt gurard. See Installing Belt Guard
on page 21.
3
Figure 16
1. Oil dipstick
2. Oil fill
3. Metal end