Toro Pro Force 44552, Руководство по обслуживанию

Страница: 108 / 134

Rotor Shaft
g280307
Figure 42
1. Flange-head screw (8 each)
5. End cap 9. Nozzle clamp
2. Front bearing cap 6. O-ring 10. Nozzle
3. Retaining ring (4 each) 7. Rear bearing cap 11. Rotor shaft
4. Bearing (2 each) 8. Center plate
Note: The rotor shaft and bearings can be serviced without removing the inner
housing from the machine.
Removing the Rotor Shaft
Refer to Figure 42 for this procedure.
1. Remove the rotor assembly; refer to Removing the Rotor Assembly (page
6–8) .
2. Loosen the nozzle clamp fasteners and remove the nozzle clamp and nozzle.
3. Remove the 4 flange-head screws that secure the front bearing cap (item 2)
to the inner housing.
4. Carefully pull the rotor shaft assembly from the inner housing. The rear
bearing cap will remain in the inner housing. Locate and retrieve the end
cap (item 4).
5. Remove the retaining rings and bearings from the rotor shaft.
6. Remove the center plate and rear bearing cap, then remove and discard
the O-ring from the rear bearing cap.
Blower Assembly: Service and Repairs Page 6–10 Pro Force® Debris Blower
18237SL Rev A