Toro MX 5050, Руководство оператора

Страница: 13 / 52

R
UN
upon release. Turning the key to the O
FF
position
stops the engine; however, always remove the key
when leaving the machine to prevent someone from
accidentally starting the engine (
Figure 5 ).
Throttle
The throttle controls the engine speed and has a
continuous variable setting from Slow to Fast (
Figure
5 ).
Blade-Control Switch (Power
Takeoff)
The blade-control switch, represented by a
power-takeoff (PTO) symbol, engages and
disengages power to the mower blades (
Figure 5 ).
Motion-Control Levers and Park
Position
The motion-control levers are speed-sensitive controls
of independent wheel motors. Moving a lever forward
or backward turns the wheel on the same side forward
or in reverse; the wheel speed is proportional to the
amount you move the lever. Move the motion-control
levers outward from the center to the P
ARK
position
when exiting the machine ( Figure 14 ). Always position
the motion-control levers into the P
ARK
position when
you stop the machine or leave it unattended.
Smart Speed
™
Control System
Lever
The Smart Speed
™
Control-System lever, located
below the operating position, gives you a choice to
drive the machine at 3 speed ranges— trim, tow, and
mow (
Figure 17 ).
Fuel-Presence Window
You can use the fuel window, located on the left side
of the machine, to verify the presence of gasoline in
the tank (
Figure 6 ).
g014521
Figure 6
1. Fuel-presence window
Height-of-Cut Lever
Use the height-of-cut lever to lower and raise the deck
from the seated position. Moving the lever up (toward
you) raises the deck from the ground and moving the
lever down (away from you) lowers the deck toward
the ground. Adjust the height-of-cut only while the
machine is not moving (
Figure 18 ).
13