Toro MX 5050, Руководство оператора

Страница: 44 / 52

g014635
Figure 59
1. Front support rod 3. Deck bracket
2. Locking nut
5. Carefully lower the front of the mower deck to
the ground.
6. Lift the mower deck and hanger brackets clear
of the rear lift rod and lower the mower carefully
to the ground (
Figure 60 ).
g005077
Figure 60
1. Mower deck 3. Rear lift rod
2. Hanger bracket
7. Slide the mower deck rearward to remove the
mower belt from the engine pulley.
8. Slide the mower deck out from underneath the
machine.
Note:
Retain all parts for future installation.
Installing the Mower
1. Park the machine on a level surface and
disengage the blade-control switch.
2. Move the motion-control levers outward to the
P
ARK
position, shut off the engine, remove the
key, and wait for all moving parts to stop before
leaving the operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest
position.
5. Lift the rear of the mower deck and guide the
hanger brackets over the rear lift rod (
Figure 60 ).
6. Attach the front support rod to the mower deck
with the clevis pin and hairpin cotter (
Figure 59 ).
7. Install the mower belt onto the engine pulley;
refer to
Replacing the Mower Belt (page 45) .
Replacing the Grass
Deflector
Service Interval: Before each use or daily—Inspect
the grass deflector for damage.
WARNING
An uncovered discharge opening could allow
the lawn mower to throw objects at you or
bystanders, resulting in serious injury. Also,
contact with the blade could occur.
Never operate the machine without the
grass deflector, the discharge cover, or the
grass-collection system in place.
Inspect the grass deflector for damage before each
use. Replace any damaged parts before use.
1. Remove the nut (3/8 inch) from the rod under
the mower (
Figure 61 ).
44