Toro MX 5050, Руководство оператора

Страница: 21 / 52

Stopping the Machine
To stop the machine, move the motion-control
levers to N
EUTRAL
and outward to the P
ARK
position,
disengage the blade-control switch, ensure that the
throttle is in the F
AST
position, and turn the ignition
key to O
FF
. Remove the key from the ignition switch.
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while
it is unattended.
Always remove the ignition key and move
the motion-control levers outward to the
P
ARK
position when leaving the machine
unattended, even if just for a few minutes.
Adjusting the Height-of-Cut
Note:
The transport position is the highest
height-of-cut position at 115 mm (4-1/2 inches) as
shown in
Figure 18 .
g027504
Figure 18
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
EUTRAL
-
LOCK
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in Figure
19 to match the closest height-of-cut position.
g010233
Figure 19
1. Anti-scalp roller 3. Flange Nut
2. Bolt 4. Hole spacing
Positioning the Seat
The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable.
21