Toro MX 5050, Руководство оператора

Страница: 18 / 52

Note:
Always engage the blades with the throttle in
the F
AST
position.
g027582
Figure 12
Disengaging the Blades
g027538
Figure 13
1. Blade-control switch—Off
Stopping the Engine
1. Disengage the blades by moving the
blade-control switch to the O
FF
position ( Figure
13 ).
2. Move the throttle lever to the F
AST
position.
3. Turn the ignition key to the O
FF
position and
remove the key.
Driving the Machine
The drive wheels turn independently, powered by
hydraulic motors on each axle. You can turn 1 side
in reverse while you turn the other forward, causing
the machine to spin rather than turn. This greatly
improves the machine maneuverability but may
require sometime for you to adapt to how it moves.
WARNING
The machine can spin very rapidly. You
may lose control of the machine and cause
personal injury or damage to the machine.
• Use caution when making turns.
• Slow the machine down before making
sharp turns.
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Set the
throttle control in the F
AST
position for performance.
For most applications, operate the machine in the
full-throttle position.
g004532
Figure 14
1. Park (brake) position 4. Backward
2. Center, unlock position 5. Front of the machine
3. Forward
18