Toro Lawn-Boy Precision Z320H, Руководство по обслуживанию

Страница: 67 / 72

A6-15 TimeCutter Z / Precision Z Service Manual
48” MOWER DECKS
6
12. To raise the front of the mower, tighten the adjust-
ment nuts. To lower the front of the mower, loosen
the adjustment nuts.
14. When the front-to-rear blade slope is correct,
tighten the locknuts and check the side-to-side
level of the mower; refer to Leveling the Mower
from Side-to-Side.
Fig A6 006 fi g. 46 G000547
Fig A6 005 fi g. 45 G000546
13. After adjusting both adjustment nuts evenly, check
the front-to-rear slope again. Continue adjusting the
nuts until the front blade tip is 1/16” - 5/16” (1.6 -
7.9mm) lower than the rear blade tip (Fig. A6 005).
Note: After adjusting the adjustment nuts, make
sure there is no slack in either support rod
(Fig. A6 006). Tighten either one to remove
the slack (Fig. A6 005).
11. To adjust the front-to-rear blade slope, remove the
locknuts and then rotate the adjustment nuts in the
front of the mower (Fig. A6 005).
A. Locknut and C. Adjustment nut
adjusting nut D. Locknut
B. Front tire
A. Hairpin cotter and B. Support rod
clevis
A A
B
B
C
D
A B