Toro Groundsmaster 4100-D 30411, Руководство оператора

Страница: 17 / 64

PTO Switch
The PTO switch (Figure 4) has three positions: On
(engage), Neutral, and Off (disengage). Carefully lift
and push the PTO switch forward to the On position
to start the implement or cutting unit blades. Slowly
pull the switch backward to the Off position to stop
implement operation.
Important:
The center lift lever must momentarily
be pushed to the lower position to enable PTO
circuit actuation by PTO switch.
Hi-Lo Speed Control
The control (Figure 4) allows the speed range to increase
for transport of the machine.
Figure 4
1. Lift lever 8. Temperature reset switch
2. Front cutting unit service
lock 9. Hour meter
3. Key switch 10. Fuel gauge
4. PTO switch
11. Throttle
5. Hi-lo speed control 12. Audible alarm
6. Cruise control (optional) 13. Power point
7. Alarm silence switch
Cruise Control (Optional)
The cruise control (Figure 4) sets the speed of the
machine.
Fuel Gauge
The fuel gauge (Figure 4) indicates the level of fuel in
the tank.
Hour Meter
The hour meter (Figure 4) shows the total hours that the
machine has been operated.
Temperature Override Switch
Press and hold the reset switch (Figure 4) to start the
engine after high temperature shut down. Use only for
emergency operation.
Audible Alarm
The alarm (Figure 4) is activated when the low engine
oil pressure light illuminates or the high coolant
temperature light illuminates.
Alarm Silence Switch
This switch (Figure 4) shuts off the audible alarm.
Throttle Control
Move the control (Figure 4) forward to increase the
engine speed and rearward to decrease the speed.
Power Point
The power point (Figure 4) is used to power optional
electrical accessories.
17