Toro Groundsmaster 3300 Series, Руководство оператора

Страница: 37 / 68

Towing the Machine
If it becomes necessary to tow or push the machine,
the traction pump must be set to bypass hydraulic
fluid.
Move the machine at a speed below 4.8 kph
(3 mph), and for a very short distance.
Important:
If towing limits are exceeded, severe
damage to the hydraulic pump may occur.
If the machine needs to be moved more than a
short distance, the machine should be transported
on a trailer.
1. Access the bypass valve from under the
machine.
g297087
Figure 36
1. Traction pump 2. Bypass valve
2. Use an 18 mm (11/16 inch) box-end wrench to
loosen the bypass valve, then open the valve 3
revolutions maximum.
Important:
Do not start or run the engine
when the valve is set to the bypass position.
3. After towing and before starting the engine,
tighten the bypass valve to 20 N·m (15 ft-lb).
Hauling the Machine
•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use full-width ramps for loading the machine into
a trailer or a truck.
•
Tie the machine down securely.
•
Remove the key before storing or hauling the
machine.
37