1.37
1.37
OPERATING THE MOWER
STARTING THE ENGINE
WARNING: PREVENT ACCIDENTS - Before starting the engine check that ;
- The area is clear of bystanders.
- The cutterdeck drive is disengaged.
- The parking brake is engaged.
- The travel control pedal is in neutral.
- You have read and understood the SAFETY PRECAUTIONS section in this
manual.
This machine is fitted with an Engine Start Lockout, refer - OPERATOR PRESENCE
CONTROLS
.
Starting a cold engine
: Set the throttle control lever to approximately 70%
full throttle.
Turn the ignition key to the ‘ignition on’ position "I" and check that the
engine oil pressure and battery charge warning lights illuminate.
Turn the ignition key to the ‘preheat’ position "II" and hold until the engine
pre-heat indicator light goes out.
Turn the ignition key to the ‘start’ position "III" and hold to crank the
engine. As soon as the engine starts release the ignition key back to position
'I'.
WARNING: PREVENT DAMAGE - When the engine is operating all warning lights should be
‘off’. If a warning light illuminates, stop the engine immediately and have the fault rectified before
restarting.
Starting a warm engine
: Engine pre-heating is unnecessary when restarting an engine which has been
stopped for a few minutes. Follow the cold engine starting procedure without holding in ‘preheat’ posi-
tion “II”.
1. Engine pre-heat
indicator light
I
II
III
O
1
HOURS
QUARTZ
CURTIS
1
10
Содержание groundsmaster 3240-d
Страница 2: ......
Страница 73: ...1 73 1 73 TRANSMISSION BRAKE HYDRAULIC CIRCUIT 23...
Страница 79: ...1 79 1 79 NOTES...
Страница 81: ......