Toro Greens Aerator, Руководство по обслуживанию

Страница: 106 / 130

10.Center thrust washer (item 16) on the pinion shaft
bearing. While squeezing shifter rods to hold shifter as-
sembly together, install pinion shaft and shifter assem-
bly into cover (Fig. 22).
11. Install reverse idler shaft (item 64), spacer (item 65)
and reverse idler gear (item 66) into cover. Note that
spacer goes between the gear and cover and the bev-
eled side of idler gear should be down into the cover.
12.Install three gear cluster (item 36) onto brake shaft.
Place thrust washer (item 16) on brake shaft.
13.Place gasket (item 30) on cover sealing surface and
then install case over differential shaft. Make sure the
case boss goes under the gears and the case edge goes
2
1
3
Figure 21
1. Two gear cluster 3. Brake shaft
2. Spacer
over the shaft rods by tilting and rotating the case in the
opposite manner in which it was removed.
14.If necessary to close the case to the cover:
A. Turn input shaft to make sure all gears mesh
properly.
B. Using needle nose pliers, agitate shifter rod ends
into their machined recesses in the case.
15.Align the case and cover with two (2) dowel pins.
Install eleven (11) flange head screws. Torque screws to
10 ft–lb (13.6 N–m).
Figure 22
NOTE: Use seal protectors during seal installation to
prevent damage to oil seals.
16.Lubricate new oil seals. Install input shaft seal (item
60) into case and brake shaft seal (item 45) into cover.
17.Lubricate and install new oil seals (item 45) and o–
rings (item 72) to oil seal retainers (item 42). Install seal
retainers to transaxle case and cover.
18.Position axle housings to transaxle noting marks
made during disassembly for correct housing orienta-
tion. Secure axle housings with lock washers (item 53)
and cap screws (item 51). Torque cap screws to 156 in–
lb (17.6 N–m).
19.Coat both sides of new shift lever housing gaskets
(item 31) with Permatex #2 (or equivalent). Install gas-
kets, shift guide plate (item 79), bracket (item 78) and
shift lever to transaxle. Secure assembly to transaxle
with three (3) socket head screws (item 1). Torque
screws to 120 in–lb (13.6 N–m).
7
3
4
5
2
6
1
8
Figure 23
1. Three gear cluster 5. Shifter rod (3rd & 4th)
2. Reverse idler gear 6. Low gear
3. Input/pinion shafts 7. Differential assembly
4. Shifter rod (Low) 8. Output gear
Drive Train
Page 7 – 16 Greens Aerator