Servicing the Fuses
The electrical system is protected by fuses, and requires no
maintenance. If a fuse blows, check the component or circuit
for a malfunction or short.
1.
Release the cushion from the rear of the machine.
2.
Pull out on the fuse to remove or replace it (
).
3.
Install the cushion to the rear of the machine.
Note:
Ensure that the correct-size fuse is installed
g017915
1
Figure 55
1.
Fuses
Drive System
Maintenance
Adjusting the Tracking
Note:
Determine the left and right sides of the machine
from the normal operating position.
1.
Push both control levers forward the same distance.
2.
Check if the machine pulls to one side.
Note:
If it does, stop the machine and set the parking
brake.
3.
Release the cushion from the rear of the machine.
4.
Rotate the right cable adjustment to position the right
motion control in the center of the control panel
neutral-lock slot (
g015241
Figure 56
1.
Left motion-control lever
3.
Neutral-locked position
2.
Right motion-control lever
4.
Align the control levers
front to back
5.
Rotate the left cable adjustment to match the left
wheel speed to the previously set right wheel speed.
6.
Adjust in quarter-turn increments until the machine
tracks straight.
Note:
Only adjust the left cable to match the left
wheel speed to the right wheel speed. Do not adjust
the right wheel speed as this will position the right
motion-control lever out of the center for the control
panel neutral-lock slot.
40
Содержание GrandStand 74574
Страница 65: ...g026979 Electrical Schematic Rev A 65 ...
Страница 66: ...Notes 66 ...
Страница 67: ...Notes 67 ...