Toro Dingo 322, Руководство оператора

Страница: 31 / 40

Maintenance
29
9. Slowly add additional oil to bring the level to the
F (full) mark on the dipstick.
10. Replace the fill cap.
Changing the Oil Filter
Replace the oil filter every 200 hours or every other
oil change.
Note: Change the oil filter more frequently
when operating conditions are
extremely hot, dusty, or sandy.
1. Drain the oil from the engine; refer to Changing
the Oil, page 28.
2. Remove the old filter and wipe the filter adapter
(Fig. 22) gasket surface.
3. Pour new oil of the proper type in through the
center hole of the filter. Stop pouring when the
oil reaches the bottom of the threads.
4. Allow a minute or two for the oil to be absorbed
by filter material, then pour off the excess oil.
5. Apply a thin coat of new oil to the rubber gasket
on the replacement filter (Fig. 22).
m–1256
1
2
3
Figure 22
1. Oil filter
2. Gasket
3. Adapter
6. Install the replacement oil filter to the filter
adapter. Turn the oil filter clockwise until the
rubber gasket contacts the filter adapter, then
tighten the filter an additional 1/2 turn (Fig. 22).
7. Fill the crankcase with the proper type of new
oil; refer to Changing the Oil, page 28.
Servicing the Spark Plugs
Check the spark plugs after every 200 operating
hours. Ensure that the air gap between the center and
side electrodes is correct before installing each spark
plug. Use a spark plug wrench for removing and
installing the spark plugs and a gapping tool/feeler
gauge to check and adjust the air gap. Install new
spark plugs if necessary.
Type: Champion RC12YC (or equivalent) Air Gap:
0.030 in. (0.76 mm)
Removing the Spark Plug
s
1. Lower the loader arms and stop the engine.
Remove the key and allow the engine to cool.
2. Pull the wires off of the spark plugs (Fig. 23).
3. Clean around the spark plugs.
4. Remove the spark plugs and metal washers.